Program Your Opener & Remote Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door. Your garage door opener receiver and remote control transmitter are set to a matching code. If you purchase additional remote controls, the garage door opener must be programmed to accept the new remote code. NOTE: Check again for completed and correct assembly of your Opener and Door. 1. Connect the Cord Plug to power supply. The Digital Display flashes with “H”, and the Light is ON. The unit is into standby (Pic. 20-1). 2. Press and hold LEARN button on the Opener for more than 2 seconds, the Digital Display indicates “·” (Pic. 20-2). Press the key twice on the remote control that you wish to operate your garage door, and “·” flashes several times before it comes to “H” (Pic. 20-3). Now the opener has learned the code. NOTE: If you want the Opener to learn additional remote codes, perform the above steps. The Opener can learn 6 remotes at most. To Erase all Remote Control Codes Press and hold LEARN button on the Opener, the Digital Display indicates “·” before it comes to “H”. The codes are now erased when the Digital Display flashes
